Couldn't Setup and configure


#1

I connected the kit to laptop and configured using method 2. But still the blue led blinks but my modem says it is connected.
Also i opened the bs.txt file on the sd card and found that it contains the ssid and password of my network.
When i connected again, still the blue led blinks.
somebody pls help me with this…


#2

HI

Here are steps to Debug the errors that occur during the Bolt Setup:

Step 1: Check if the Red LED on Bolt is On. If it is not On then it means your Bolt is not powered on. Use a 5V Micro USB Power Adaptor connected to a power supply mains to power on the Bolt.

The Bolt may not work if power via a USB of a computer.

Step 2: Check if the SD card on Bolt is correctly inserted. The SD card should not be loose.

Step 3. Check for the Blue LED on Bolt.

If it is blinking then it means your Bolt is not connected to a WiFi network/router. In that case, go to this link and proceed.: Bolt Blue LED Blinking But Unable to Connected

If the Blue LED is not blinking and is stable means it is connected to the WiFi Network. In that case click here to proceed: Unable to FInd the IP Address of Bolt

Mail us at support@botiot.com for further assistance.