Hardware configure

how to configure hardware for controlling led project?

Hardware required

The Bolt Wifi module

1 x 330 ohm Resistor

1 x LED

Step 1: Take one leg of the resistor and wrap it around the longer leg of the LED i.e positive leg
Step 2: Insert the negative leg of the LED into the ground pin of the Bolt.
Step 3: Insert the other leg of the resistor in digital pin 0 of the Bolt.

Note: longerleg(positive leg) and shorterleg(negative leg)

Required H/w components:
1.The Bolt wifi module
2.1330 ohm resistor
3.1
LED

As you can see Led has 2 legs.So the longer leg is always connected to any GPIO pin and the shorter leg is always connected to gnd.
Take one leg of the resistor and wrap it around the longer leg of leg (+ve leg)and other leg of resistor (-ve)and insert in digital pin 0 of the Bolt
But keep the BOLT device turned off untill your is Led is connected.

i am asking about hardware tab in create product?

In the led project, you just need to create the product and link it to your device.

There is no need for hardware configuration, just write your code, save it and click on “view this device” to control led.

Thanks.

1 Like