Plant monitor system

[sunty.apple]

while executing,I getting same values like 1.02 thousand ,even when I kept in darkness and light mode.

my code and result I mentioned in above images.
please help me friends.
those who are replying ,please provide your contact number,so that I will contact u directly,without waiting for long time.
because I am new to this ,so that I asking friends.

[ramayanamsupraja]

Hi!once you restart the device.therefore you can see a change in your observations:slightly_smiling_face:

[yeshwant.naik]

Regarding setTimeInterval() Function

@sunty.apple Are you using a resistor in series with the light sensor as mentioned in the training? If not please use it. The A0 pin can detect voltage levels from 0 to 1V and converts it to equivalent range of 0 to 1023. Your sensor must be getting voltage greater than 1V even in the dark room. Using a resistor should solve your problem. If you are already using it, please share a pic of the connection that you have made.

[khushimishra26peace]

Hi! This same issue happened with me, however, please make sure that the connections you’ve made are correct and the 5 volt (of the LDR) and ground wire (of the resistor) are not touching at all with each other, my graph therefore was plotted correctly, and i received different values, for light and dark room simulations. Thank you.